Let's unleash the Greatness with this Dead Goat Deck!

Please note the new cap is required to use the build deck, found at RecoilRDA.com

Includes both squonk and non-squonk pins

Does require Allen key to swap squonk pin to non squonk 

These coils create a hot, dense vape made for parallel and regulated mods only.* A good favorite for those who are looking for the most vapor production!

• 6 pieces .3 ribbon wire sandwiched between 2-28g frames and a 36g outer alien wrap
• Wrapped with a 3mm diameter
• Dual coil = 0.09-0.11 ohm, Single coil = 0.19-0.21 ohm
• Using all high quality Twistedmesses Nichrome80 (TMN80) and Kidney Puncher ribbon wire
• Two(2) individual coils per set
• Ultrasonically cleaned

* DO NOT use with unregulated SERIES devices. DO NOT use batteries with tears in the wrap. Please use quality, high drain batteries only. Always be aware of Ohms Law and SAFETY FIRST! 

It's just one of those things that every person should have on their build station! Keep your table clean from liquid and scratches! These are quality mats made by @vapemats himself! Mats are 24"x12"

Nichrome 80 series resistance wire is composed of 20% Chromium and ~80% Nickel. It’s a low resistance wire under normal circumstances. When dealing with the thinner gauges of this wire (36 - 40g) the resistance is much higher than you’d expect.

The thinner gauges (36-40g) are for clapton coils, multi-strand twisting or to add a bit of color to your coil-art.

The 27g, 28g and 30g can be used for core wires of multi-strand claptons like Alien Claptons but the thinner gauges (36-40g) will not perform well as a standard coil, so if you’ve never used high-gauge wire before, make sure you’re buying the appropriate wire for your build before purchasing.